The vehicle sensor lets you know any time a vehicle enter or exits
your property. The vehicle sensor detects metal and is activated by
the movement of a vehicle or any metal object within a 14 foot area of
the sensor.
The vehicle sensor probe best operates when buried about 6 inches
deep beside or under your driveway. Then run the wire to the house and
connect it to the control unit. The actual size of the probe 1 inch by
15 inches. Plug the control unit into a wall outlet and it will ring
like a doorbell when someone drives by the sensor. The driveway bell
will ring for about two seconds but may adjusted to ring up to twenty
seconds for those who require a longer audible sound.
The basic unit consists of one control unit with one bell as well
as one vehicle sensor with 100 feet of wire. Additional wire, bells,
and sensor may be added. If you wish additional wire the vehicle
sensor will come with the necessary length so that no splicing will be
necessary.
Installation is very simple. No electrician is necessary. A chain
saw or lawn edger works well to dig a trench about 3 inches deep to
bury the wire or you may rent a gas powered trencher from the local
rental center. After digging the trench bury the 3 strand shielded
exterior wire ( about 1/4" in diameter). Then connect the wire from
the vehicle sensor to the control unit and plug the driveway bell into
the wall outlet and you are ready.
The control unit is a 24 volt system and can activate our light
controls, sirens, telephone tape dialer , etc.
To expand your driveway alarm system please review the
accessories page
$199.95
FOUR CONVENIENT WAYS TO
ORDER:
PHONE: 1-800-641-4111
FAX IN UNITED STATES:
1-888-814-7526
INTERNATIONAL FAX LINE:
1-253-981-7903
OR USE SECURE SHOPPING CART BELOW
